Home
Back
Lean-To Pitch Formula:
| From: | To: |
Lean-To Pitch is a ratio that represents the slope of a lean-to roof, calculated as the vertical rise divided by the horizontal run. It helps determine the angle and steepness of the roof for proper water drainage and structural design.
The calculator uses the simple formula:
Where:
Explanation: The pitch is expressed as a unitless ratio that represents how much the roof rises for each unit of horizontal run.
Details: Proper roof pitch calculation is essential for ensuring adequate water drainage, determining appropriate roofing materials, meeting building code requirements, and creating structurally sound roof designs.
Tips: Enter both rise and total run measurements in meters. Both values must be positive numbers greater than zero for accurate calculation.
Q1: What is considered a good pitch for a lean-to roof?
A: A minimum pitch of 1:80 (0.0125) is typically recommended for adequate water drainage, but local building codes may specify different requirements.
Q2: How do I convert pitch ratio to degrees?
A: To convert pitch to degrees, use the formula: angle = arctan(pitch). Most pitch ratios range between 0.1 and 0.5 (approximately 6-27 degrees).
Q3: Can I use different units of measurement?
A: Yes, as long as both rise and run use the same units, the pitch ratio will be correct. The calculator currently accepts meters, but you can convert from other units before entering values.
Q4: What's the difference between pitch and slope?
A: Pitch is typically expressed as a ratio (rise:run), while slope is often expressed as a percentage (rise/run × 100%). Both describe the steepness of a roof.
Q5: Are there limitations to lean-to roof designs?
A: Lean-to roofs work best for smaller structures and may have limitations in areas with heavy snow loads. Always consult local building codes and a structural engineer for specific applications.